Form No. 3369-161 Rev A
Registration Plate Kit
Groundsmaster
®
360 Series Multi-Purpose Machine
Model No. 120-6678
Installation Instructions
Note:
The Groundsmaster 360 Series Multi-Purpose
Machine must be equipped with the Light Kit, Model
30512 or 30516 to operate the Registration Plate Kit
Light.
1. Position the machine on a level surface, stop the
engine, remove the ignition key and engage the
parking brake.
CAUTION
If you leave the key in the ignition switch,
someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition switch before
you do any maintenance.
Figure 1
1.
Registration plate bracket
6.
Flange head nut, 5/16 inch
2.
Screws, #10 x 5/8 inch
7.
Tree bracket
3.
Plate light
8.
Plastic tree plug (shown removed for clarity)
4.
Flange head screw, 5/16 x .613 inch
9.
Wire harness
5.
Lock nut, #10
10.
Drill a 13 mm diameter hole here
2. Centering the registration plate bracket on the rear
of the hood, use it as a template to locate, mark
and drill (2) 9 mm diameter holes through the hood
(Figure 1).
3. At the approximate location shown in Figure 1, mark
and drill a 13 mm diameter hole through the interior
wall of the hood, near the seal bracket.
4. Route the bullet connector end of the wire harness
through the drilled hole.
© 2011—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA.
All Rights Reserved
