Gear Pump (P2) Service
g303051
Figure 55
1.
Shaft seal (2 each)
7.
Thrust plate (2 each)
13.
Seal
2.
Retaining ring
8.
Driven gear
14.
Rear cover
3.
Backup washer
9.
Drive shaft
15.
Washer (4 each)
4.
Front cover
10.
Dowel pin (4 each)
16.
Cap screw (4 each)
5.
Uni-ring (2 each)
11.
Seal
6.
Pressure seal (2 each)
12.
Body
If items other than the pump seals are worn or damaged, the gear pump must be
replaced as a complete assembly. Individual gears, housings and thrust plates
are not available separately. Disassemble, inspect, and assemble the gear pump
for cleaning, inspection and seal replacement only.
Disassembling the Gear Pump
1. Plug the pump ports and thoroughly clean the exterior of the pump with
cleaning solvent. Make sure the work area is clean.
2. Use a marker to make diagonal lines across the gear pump sections for
assembly purposes.
Hydraulic System: Service and Repairs
Page 5–78
Groundsmaster
®
3200, 3300 and 3310
19240SL Rev A
Summary of Contents for Groundmaster 31900
