Checking the Brake Adjustment (continued)
parking brake. If the gaps do not increase when the manual parking brake is
engaged, adjust the brake cable: refer to
Adjusting the Brake Cable (page
.
Adjusting the Brake Linkage
1. Park the machine on a level surface, set the key switch to the O
FF
position
and remove the key.
2. Loosen the hex nuts and adjust the eye bolt as far as possible to relax the
extension spring. Remove the spring.
g283623
Figure 114
1.
Front traction motor – RH
4.
Extension spring
2.
Hex nut (2 each)
5.
Upper brake arm – RH
3.
Eye bolt
6.
Brake rod assembly
3. Use the 3/8 inch square drive hole in the right side upper brake arm to fully
retract the brake actuator.
4. If either brake rod assembly was removed, repaired, or replaced:
A. Check the brake rod assembly and adjust as necessary:
B. Set the spring length to
36 to 40 mm (1.44 to 1.56 inch)
and tighten
the jam nuts.
C. Set the overall length to
282 to 285 mm (11.11 to 11.23 inch)
and
tighten the clevis nut.
Chassis: Adjustments
Page 6–4
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
