Service
Menu Item
Description
H
OURS
Lists the total number of
hours that the key, reels, and
backlap have been on.
C
OUNTS
Lists the number of mows,
tap-offs, and backlaps.
B
ACKLAP
Engages/disengages the
cutting-unit backlap procedure
(when you engage this
procedure, you can disengage
the mode with this setting or
by moving the key to the O
FF
position).
C
ALIBRATION
Allows you to calibrate the
steering system, traction
system, and lift actuators.
Refer to the
Service Manual
for more information on
calibration.
Settings
Menu Item
Description
U
NITS
Controls the units used on the
InfoCenter. The menu choices
are English or metric.
L
ANGUAGE
Controls the language used
on the InfoCenter.
B
ACKLIGHT
Controls the brightness of the
LCD display.
C
ONTRAST
Controls the contrast of the
LCD display.
P
ROTECTED
M
ENUS
Allows you to access
protected menus by inputting
a passcode.
P
ROTECT
S
ETTINGS
Controls the protected menus.
R
ESET
D
EFAULTS
Resets the InfoCenter to
default settings.
T
APOFF
T
IME
Controls the tap-off delay.
R
EEL
S
PEED
Controls the reel speed.
B
ACKLAP RPM
Controls the backlap rpm
speed.
C
LIP
C
ONTROL
Turns the automatic
clip-control feature O
N
/O
FF
.
B
LADE
C
OUNT
Set the number of blades in
each reel. This setting is only
necessary if C
LIP
C
ONTROL
is
set to O
N
.
H
EIGHT OF
C
UT
(HOC)
Sets the desired height of cut.
This setting is only necessary
if C
LIP
C
ONTROL
is set to O
N
.
M
AX
M
OW
Sets the maximum machine
speed while mowing.
M
AX
T
RANSPORT
Sets the maximum machine
speed while transporting.
Settings (cont'd.)
M
AX
R
EVERSE
Sets the maximum machine
speed while moving the
machine in reverse.
S
LOW
& T
URN
Enables or disables the slow
and turn function.
3WD K
IT
Enables or disables the
3-Wheel Drive Kit.
B
ATT
. R
ESERVE
Sets the distance that is
needed to transport the
machine back to the shop
when the battery level
becomes low.
About
Menu Item
Description
M
ODEL
Lists the model number of the
machine.
SN
Lists the serial number of the
machine.
S/W Rev
Lists the software revision of
the master controller.
I
NFO
C
ENTER
Lists the software revision of
the InfoCenter.
CU1
Lists the software revision of
the center cutting unit motor .
CU2
Lists the software revision of
the front, left cutting unit motor.
CU3
List the software revision of
the front, right cutting unit
motor.
LL1
Lists the software part number
and the revision version for
the center cutting unit.
LL2
Lists the software part number
and the revision version for
the front left cutting unit.
LL3
Lists the software part number
and the revision version for
the front right cutting unit.
T
RACTION
1
Lists the software part number
and the revision version for
the front right traction motor.
T
RACTION
2
Lists the software part number
and the revision version for
the front left traction motor.
S
TEERING
Lists the software part number
and the revision version for
the rear steering motor.
P
RECHARGE
Lists the software part number
and the revision version for
the precharge controller.
19
