Toro Greensmaster 120-9600, Installation Instructions

Page: 1 / 2

Form No. 3390-822 Rev A
High Height-of-Cut Kit
Greensmaster ® DPA Reel Mowers
Model No. 120-9600
Installation Instructions
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals
known to the State of California to cause cancer,
birth defects, or reproductive harm.
1. Disengage the drives, lower the reels, set the parking
brake, and stop the engine before adjusting the rollers.
2. Loosen the screws securing the front roller shaft to the
height-of-cut arms (
Figure 1 ).
3. Remove the front roller ( Figure 1 ).
4. Remove the plow bolts, washers and nuts securing the
height-of-cut arms to the cutting unit side plate (
Figure
1 ).
5. Remove the height-of-cut arms.
6. Remove the adjusting screws from the height-of-cut
arms (
Figure 1 ).
4
g017167
Figure 1
1. Height-of-cut arm 3. Adjusting screw
2. Plow bolt, washer, and
flange nut 4. Screw
7. Apply an anti-seize lubricant to the threads of the
adjusting screws. Thread the screws into the new
height-of-cut arms.
8. Loosely mount the height-of-cut arms to the cutting
unit side plates with the plow bolts, washers, and nuts
previously removed.
9. Install the roller into the height-of-cut arms.
10. Center the roller between the height-of-cut arms.
Install and tighten the new screws securing the roller
shaft to the height-of-cut arms.
11. Remove the screws and nuts securing the rear roller
brackets and spacers to the side plate mounting flanges
(
Figure 2 ). Discard the screws and nuts.
g017200
Figure 2
1. Spacers 3. Rear roller bracket
2. Side plate mounting flange
Note:
Older Flex 21 cutting units do not have a side
plate mounting flange ( Figure 2 ). Skip steps 11 - 14 if
the kit is being installed on an older model unit and
discard the spacers.
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420 Register at www.Toro.com. Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3390-822* A