Form No. 3361-684 Rev A
GrandStand
™
Mowers
All GrandStand
™
Mowers
Addendum
Ensure the traction rollers are lubricated at the new
interval. Keep this addendum with your
Operator’s
Manual
.
Lubricating the Machine
Service Interval:
Every 200 hours/Yearly (whichever
comes first)—Lubricate the traction
rollers (more often in dirty or dusty
conditions).
Lubricate the traction rollers with a dry lubricant
(PTFE).
Figure 1
Adjusting the Speed Control
Lever
1. Disengage the PTO, move the right side motion
control lever to the neutral position and set the
parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Move the HOC lever to the 1 inch height-of-cut
position (lowest position) (Figure 2).
4. Move the speed control lever to the fast position
5. Hold the motion control levers fully forward.
Figure 2
1.
Motion control levers fully
forward
3.
HOC lever in the 1 inch
height-of-cut position
(lowest position)
2.
Speed control lever in fast
position
6. Locate the cable and cable clamp under the frame in
front of the left wheel, as shown (Figure 3).
7. Loosen the cable clamp and pull the cable towards
rear of the unit until tight (Figure 3).
8. Tighten the cable clamp but not so tight that it
restricts the travel of the cable (Figure 3).
Figure 3
1.
Clamp
2.
Cable
© 2008—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA.
All Rights Reserved
