Adjusting the Height-of-Cut
The height-of-cut can be adjusted from 38 to 127 mm
(1-1/2 to 5 inches) in 6 mm (1/4 inch) increments.
g330789
Figure 29
Adjusting the Slope of the
Mower Deck
You can raise the rear of the mower deck in 6.3 mm
(1/4 inch) increments, up to 31.8 mm (1-1/2 inch).
1.
Disengage the PTO and move the motion-control
levers outward to the P
ARK
position.
2.
Shut off the machine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Raise the height-of-cut lever and lock it into the
transport position.
4.
On the left or right side of the machine, raise the
lever and remove the pin.
g377014
Figure 30
5.
Install the pin at the desired position.
g377012
Figure 31
6.
Repeat the procedure for the other side of the
machine.
23
