Toro GrandStand 74583, Operator'S Manual

Page: 21 / 68

Figure 19
Driving Backward
1. Move the right side motion control lever to the
center, un-locked position.
2. Slowly pull the motion control levers rearward
(Figure 20).
Figure 20
Stopping the Machine
To stop the machine, move the motion control levers to
neutral, move the right side motion control lever into
the neutral lock position, disengage the power take off
(PTO), and turn the ignition key to off.
Set the parking brake when you leave the machine; refer
to Setting the Parking Brake in Operation. Remember
to remove the key from the ignition switch.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the tractor while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.
Using the Rotation Indicator
The slots in the top of the belt covers allow the
operator to verify if the blades have stopped rotating
after disengaging the power take-off (PTO) switch.
Disengage the power take-off (PTO) switch, stop the
engine, remove the key, and wait for all moving parts to
stop before leaving the operating position.
G015493
1
1 2
1
Figure 21
52 inch mower deck shown
1. Rotation Indicator - slots in
the top of the belt cover 2. Side discharge chute
Pushing the Machine by Hand
The by-pass valves allow the machine to be pushed by
hand without the engine running.
Important:
Always push the machine by hand.
Never tow the machine because hydraulic damage
may occur.
21