Pushing the Machine by Hand
The bypass valves allow you to push the machine by hand
without the engine running.
Important:
Always push the machine by hand. Do not
tow the machine, because hydraulic damage may occur.
Important:
Do not start or operate the machine with
the bypass valves open. Damage to system may occur.
Figure 23
Transporting the Machine
Use a heavy-duty trailer or truck to transport the machine.
Ensure that the trailer or truck has all the necessary brakes,
lighting, and marking as required by law. Please carefully read
all the safety instructions.
1.
Raise the platform of the machine before driving onto
the trailer or truck.
2.
If using a trailer, connect it to the towing vehicle and
connect the safety chains.
3.
If applicable, connect the trailer brakes.
4.
Load the machine onto the trailer or truck.
5.
Shut off the engine, remove the key, set the brake, and
close the fuel valve.
6.
Use the metal tie-down loops on the machine to
securely fasten the machine to the trailer or truck with
straps, chains, cable, or ropes (
Figure 24
1.
Traction unit tie-down loop
Loading the Machine
Use extreme caution when loading or unloading machines
onto a trailer or a truck. Use a full-width ramp that is wider
than the machine for this procedure. Back the machine up the
ramp and walk it forward down the ramp (
Figure 25
1.
Back the machine up the
ramp.
2.
Walk the machine down
the ramp.
22
Summary of Contents for GrandStand 74504
Page 58: ...Schematics Electrical Schematic Rev A 58 ...
Page 59: ...Notes 59 ...
