Figure 67
1.
Cam
2.
Nut
8.
Adjust the cam until it aligns with the left
motion-control lever and tighten the nut for the cam.
Note:
Moving the cam clockwise (in the vertical
position) lowers the handle; moving the cam
counterclockwise (in the vertical position) raises the
handle.
Important:
Ensure that the flat portion of the
cam does not go above a vertical position (right or
left); otherwise you may damage the switch.
9.
Repeat steps
through
for the left motion-control
lever.
Hydraulic System
Maintenance
Servicing the Hydraulic
System
Hydraulic Fluid Type:
Toro
®
HYPR-OIL
™
500 hydraulic
oil
Hydraulic System Fluid Capacity:
4.7 L (5 US qt)
Important:
Use the fluid specified. Other fluids could
damage the system.
Checking the Hydraulic Fluid
Service Interval:
After the first 8 hours
Every 500 hours
Note:
Check the hydraulic fluid level when the fluid is cold.
1.
Position the machine on a level surface.
2.
Disengage the power takeoff (PTO) and shut off the
engine.
3.
Wait for all moving parts to stop and set the parking
brake before leaving the operating position.
4.
Clean the area around the cap and the filler neck of the
hydraulic tank (
).
Figure 68
1.
Hydraulic-tank cap
2.
Fill level
5.
Remove the cap from the filler neck (
).
Note:
Look inside to check the fluid level in the
reservoir.
6.
Add fluid to the reservoir until it reaches the fill level.
7.
Install the cap on the filler neck.
46
Summary of Contents for GrandStand 74504
Page 58: ...Schematics Electrical Schematic Rev A 58 ...
Page 59: ...Notes 59 ...
