7.
Remove the deck belt from the clutch and clutch stop
(
).
8.
Install the new belt.
9.
Install the tension spring and lower hydraulic hose.
10.
Install the drain plugs.
11.
Add hydraulic fluid to the fill level.
12.
Install the hydraulic-reservoir cap.
13.
Run the machine for 10 minutes and verify that the
hydraulic fluid is at the correct level.
Controls System
Maintenance
Adjusting the Motion-Control
Levers
If the motion-control levers do not align horizontally, adjust
the right side motion-control lever.
1.
Disengage the PTO, move the motion-control levers to
the neutral position, and set the parking brake.
2.
Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3.
Push the motion-control levers down out of the
N
EUTRAL
-
LOCK
position (
4.
Check if the right motion-control lever aligns
horizontally with the left motion-control lever (
Figure 66
1.
Left motion-control lever
3.
Check the horizontal
alignment here
2.
Right motion-control lever
in the Neutral-lock position
4.
Right motion-control lever
5.
To adjust the motion-control levers horizontally, you
must adjust the cam.
6.
Release the cushion from the rear of the machine.
7.
Loosen the nut holding the cam (
).
45
Summary of Contents for GrandStand 74504
Page 58: ...Schematics Electrical Schematic Rev A 58 ...
Page 59: ...Notes 59 ...
