Form No. 3373-815 Rev A
Light Kit
GrandStand
®
Mower
Model No. 114-3505
Installation Instructions
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
Bracket
2
1
Bolt (3/8 x 1 inch) (self tapping)
4
Install the brackets.
Right light
1
Left light (has button switch)
1
Locknut (5/16 inch)
2
Wire harness
1
Fuse (15 amp)
1
Convoluted tube
2
Plastic tie
8
Friction washer
2
2
Y-Adapter
1
Install the lights.
1
Installing the Brackets
Parts needed for this procedure:
2
Bracket
4
Bolt (3/8 x 1 inch) (self tapping)
Procedure
1.
Stop the engine, set the parking brake, and remove the
key from the ignition switch (Figure 1).
2.
Remove the negative (-) battery cable from the battery.
3.
Install the 2 brackets to the side of the machine with 4
bolts (3/8 x 1 inch).
Note:
These are thread-forming (self-tapping) bolts
and the frame holes do not require tapping.
Figure 1
1.
Self-tapping bolt (3/8 x 1
inch)
3.
Control levers
2.
Bracket
© 2012—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA.
All Rights Reserved
*3373-815* A
