Toro 88713, Operator'S Manual

Page: 16 / 52

Troubleshooting
Perform only the steps described in these instructions. All further inspection, maintenance, and repair work
must be performed by an authorized service center or a similarly qualified specialist if you cannot solve the
problem yourself.
Problem Possible Cause Corrective Action
1. The battery is not fully installed in the
tool.
1. Remove and then replace the battery
into the tool, making sure that it is fully
installed and latched.
2. The battery pack is not charged. 2. Remove the battery pack from the tool
and charge it.
3. The battery pack is damaged. 3. Replace the battery pack.
The tool does not start.
4. There is another electrical problem
with the tool.
4. Contact an Authorized Service Dealer.
1. The battery pack charge capacity is
too low.
1. Remove the battery pack from the tool
and fully charge the battery pack.
The tool does not reach full power.
2. The air vents are blocked. 2. Clean the air vents.
The tool is producing excessive vibration
or noise. 1. The blades are dull or damaged. 1. Contact an Authorized Service Dealer.
1. The battery pack is over or under the
appropriate temperature range.
1. Move the battery pack to a place
where it is dry and the temperature is
between 5°C (41°F) and 40°C (104°F).
The battery pack loses charge quickly.
2. The machine is overloaded 2. Trim at a slower pace.
14