Form No. 3355-379 Rev B
Blower and Drive Kit
For 52in E-Z Vac® Bagger for Z400 and Z500 Series Z
Master® Mowers
Model No. 78537—Serial No. 260000001 and Up
Installation Instructions
Note:
Determine the left and right sides of the machine from the normal operating position.
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Description
Qty.
Use
1
No parts required
–
Verify an existing pivot tube.
2
No parts required
–
Prepare the mower and remove the
belt cover.
3
No parts required
–
Remove the existing anti-scalp
roller and bracket.
4
Pulley assembly
1
Install the pulley assembly.
Pivot bracket
1
Metal template
1
Bolt (3/8 x 1 inch)
3
5
Locknut (3/8 inch)
3
Install the pivot bracket.
Blower assembly
1
Bagger belt
1
6
Blower belt cover
1
Install the blower, bagger belt,
spring, and belt cover.
Step
1
Verifying an Existing Pivot
Tube
No Parts Required
Procedure
If your mower has a pivot tube as shown in Figure
1, then proceed to Step 6 and the Operator’s
Manual to install the blower assembly.
Note:
Do not remove the existing pivot tube.
Figure 1
1. Z400 mower deck
3. Z500 mower deck
2. Pivot tube
4. Pivot tube
© 2006—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA.
All Rights Reserved
