Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
1
No parts required
–
Prepare the machine.
Bagger bracket
1
Bolt (5/16 x 1 inch)
8
2
Flange nut (5/16 inch)
8
Install the bagger bracket (Z400 Mowers
with 48-inch mower decks).
Bagger bracket
1
Bolt (5/16 x 1 inch)
8
3
Flange nut (5/16 inch)
8
Install the bagger bracket (All Z400
Mowers with 52-inch mower decks).
Hood assembly
1
Bags
2
Clevis pin
2
4
Hairpin cotter
2
Install the hood assembly and bags.
5
Bagger belt (from Blower and Drive Kit)
1
Route the bagger belt into the blower
assembly.
Blower assembly (from Blower and
Drive Kit)
1
6
Spring (from Blower and Drive Kit)
1
Install the blower assembly.
7
No parts required
–
Adjust the flow baffle.
Upper tube
1
Lower tube
1
Bolt (#10 x 3/4 inches)
3
Locknut (#10)
3
8
Washer (7/32 inch)
3
Install the discharge tubes.
9
No parts required
–
Install the belt cover.
Weight
1
Bolt (3/8 x 2 inches)
2
Locknut (3/8 inch)
2
10
Washer (3/8 inch)
4
Install the weight for a 48-inch bagger.
Weight
2
Bolt (3/8 x 3 inches)
2
Locknut (3/8 inch)
2
11
Washer (3/8 inch)
4
Install the weights for a 52-inch bagger.
12
No parts required
–
Adjust the parking brake.
13
No parts required
–
Check the tire pressure.
Note:
Determine the left and right sides of the machine from the normal operating position.
5
