Toro 78463, Operator'S Manual

Page: 14 / 36

8
Removing the Existing
Belt Cover, Bracket, and
Discharge Chute
No Parts Required
Procedure
Note:
Clean the area around the belt cover before
removing it.
1. Lower the mower deck to the lowest height-of-cut
position.
2. Remove the right belt cover ( Figure 15 ).
g038092
Figure 15
3. Remove the right belt-cover bracket, 2 washers
(60-inch mower deck only) , and 2 flange nuts
from the mower deck ( Figure 16 ).
Note:
Retain the hardware that you removed
during this procedure so that it is available for
changeover.
g038093
Figure 16
1. Right belt-cover bracket 3. Flange nuts
2. Washers-only on 152 cm
(60 inch) mower deck
4. Remove the locknut, bolt, spring, and spacer
holding the deflector to the pivot brackets
(
Figure 17 ).
g015594
Figure 17
1. Bolt 5. Spring installed
2. Spacer 6. Grass deflector
3. Locknut 7. J-hook end of spring
4. Spring
5. Remove the grass deflector ( Figure 17 ).
Note:
Retain the hardware that you removed
during this procedure so that it is available for
changeover.
9
Installing the CE Kit
For CE Machines Only
Parts needed for this procedure:
1 CE Kit
Procedure
For CE machines, you need to install the CE Kit; refer
to the
Declaration of Conformity for the CE Kit model
number.
14