Toro 75744, Operator'S Manual

Page: 13 / 52

g293796
Figure 8
Performing Daily
Maintenance
Before starting the machine each day, perform the
Each Use/Daily procedures listed in
Maintenance
(page 26) .
Breaking in a New Machine
New engines take time to develop full power. Mower
decks and drive systems have higher friction when
new, placing additional load on the engine. Allow
40 to 50 hours of break-in time for new machines to
develop full power and best performance.
Using the Safety-Interlock
System
WARNING
If the safety-interlock switches are
disconnected or damaged, the machine could
operate unexpectedly, causing personal
injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock
switches daily and replace any damaged
switches before operating the machine.
Understanding the
Safety-Interlock System
The safety-interlock system is designed to prevent the
engine from starting unless:
•
The blade-control switch (PTO) is disengaged.
•
The motion-control levers are in the P
ARK
position.
The safety-interlock system also is designed to shut
off the engine whenever the control levers are out of
the P
ARK
position and you rise from the seat.
Testing the Safety-Interlock
System
Test the safety-interlock system before you use the
machine each time. If the safety system does not
operate as described below, have an Authorized
Service Dealer repair the safety system immediately.
1. Sit on the seat, move the motion-control levers
in the P
ARK
position, and move the blade-control
switch to the O
N
position. Try starting the
engine; the engine should not crank.
2. Sit on the seat and move the blade-control switch
to the O
FF
position. Move either motion-control
lever to the center, unlocked position. Try
starting the engine; the engine should not crank.
Repeat with the other motion-control lever.
3. Sit on the seat, move the blade-control switch
to the O
FF
position, and lock the motion-control
levers in the P
ARK
position. Start the engine.
While the engine is running, engage the
blade-control switch, and rise slightly from the
seat; the engine should shut off.
4. Sit on the seat, move the blade-control switch
to the O
FF
position, and lock the motion-control
levers in the P
ARK
position. Start the engine.
While the engine is running, move the
motion-control levers to the center, unlocked
position, engage the blade-control switch, and
rise slightly from the seat; the engine should
shut off.
13