Figure 61
1.
Cutting Edge
3.
Wear/slot Forming
2.
Curved Area
4.
Crack
Checking for Bent Blades
Note:
The machine must be on a level surface for the
following procedure.
1.
Raise the mower deck to the highest height-of-cut
position; also considered the 'transport' position.
2.
While wearing thickly padded gloves or other adequate
hand protection slowly rotate blade to be measured
into a position that allows effective measurement of
the distance between the cutting edge and the level
surface the machine is on.
G014972
1
2
3
Figure 62
1.
Deck
3.
Blade
2.
Spindle housing
3.
Measure from the tip of the blade to the flat surface
here.
G014973
1
2
3
Figure 63
1.
Blade, in position for measuring
2.
Level surface
3.
Measured distance between blade and surface (A)
4.
Rotate the same blade 180 degrees so that the opposing
cutting edge is now in the same position.
G014974
1
2
3
Figure 64
1.
Blade, side previously measured
2.
Measurement position used previously
3.
Opposing side of blade being moved into measurement
position
5.
Measure from the tip of the blade to the flat surface
here. The variance should be no more than 1/8 inch
(3mm).
G014973
1
2
3
Figure 65
1.
Opposing blade edge, in position for measuring
2.
Level surface
3.
Second measured distance between blade and surface (B)
44
Summary of Contents for 74920 TITAN ZX4820
