3.
Measure from the tip of the blade to the flat surface
here.
G009680
1
2
3
Figure 43
1.
Blade, in position for measuring
2.
Level surface
3.
Measured distance between blade and surface (A)
4.
Rotate the same blade 180 degrees so that the opposing
cutting edge is now in the same position.
G009681
1
2
3
Figure 44
1.
Blade, side previously measured
2.
Measurement position used previously
3.
Opposing side of blade being moved into measurement
position
5.
Measure from the tip of the blade to the flat surface
here. The variance should be no more than 3 mm (1/8
inch).
G009680
1
2
3
Figure 45
1.
Opposing blade edge, in position for measuring
2.
Level surface
3.
Second measured distance between blade and surface (B)
WARNING
A blade that is bent or damaged could break
apart and could seriously injure or kill you or
bystanders.
•
Always replace bent or damaged blade
with a new blade.
•
Never file or create sharp notches in the
edges or surfaces of blade.
A.
If the difference between A and B is greater than 3
mm (1/8 inch) replace the blade with a new blade.
Refer to Removing the Blades and Installing the
Blades.
Note:
If a bent blade is replaced with a new one
and the dimension obtained continues to exceed 3
mm (1/8 inch), the blade spindle could be bent.
Contact an Authorized Toro Dealer for service.
B.
If the variance is within constraints, move to the
next blade.
Repeat this procedure on each blade.
33
Summary of Contents for 74385 TimeCutter ZS 3200
Page 44: ...Schematics G014644 Electrical Diagram Rev A 44 ...
Page 45: ...Notes 45 ...
Page 46: ...Notes 46 ...
