Toro 60213, Operator'S Manual

Page: 42 / 52

13. Install the filler bolt and washer to the filler port
of the reduction case and tighten the filler bolt
(
Figure 62 ).
14. Install the engine; refer to Installing the Engine
(page 38) .
Belt Maintenance
Inspecting the Belts
Service Interval: After the first 25 hours—Inspect
the belts and adjust as necessary
(belt-drive models only).
Every 40 hours—Inspect the belts and adjust as
necessary (belt-drive models only).
1. Park the machine on a level surface and shut
off the engine.
2. Allow the machine to cool.
3. Disconnect the wire from the spark plug; refer to
Disconnecting the Spark-Plug Wire (page 28) .
4. Remove the divider plate; refer to Removing the
Divider Plate (page 28) .
5. Move the clutch lever to the O
FF
position.
6. Examine the belts for wear or damage. If the
belts are worn or damaged, replace them; refer
to
Replacing the Belts (page 44) .
7. Examine the pulleys for wear, damage, and
misalignment; refer to
Aligning the Pulleys (page
45) .
8. Install the divider plate; refer to Installing the
Divider Plate (page 28) .
Adjusting the Belt Tension
Clutch air gap: 2.5 to 6.5 mm (3/32 to 1/4 inch)
1. Park the machine on a level surface and shut
off the engine.
2. Allow the machine to cool.
3. Disconnect the wire from the spark plug; refer to
Disconnecting the Spark-Plug Wire (page 28) .
4. Move the clutch lever to the O
N
position.
5. Measure the air gap between the engine deck
and the roller on the clutch (
Figure 64 ).
42