Toro 30839, Operator'S Manual, Page: 21 / 60

g031596
Figure 22
1. Speed-stop screw
Tilt-Steering Lever
Pull the tilt-steering lever back to tilt the steering wheel
to the desired position, then push the lever forward to
tighten (
Figure 21 ).
Indicator Slot
Models 30807, 30839, and 30849 Only
The indicator slot in the operator platform indicates
when the cutting units are in the center position
(
Figure 21 ) .
Angle Indicator
Models 30807, 30839, and 30849 Only
The angle indicator indicates the side-hill angle of the
machine in degrees (
Figure 21 ).
Ignition Switch
The ignition switch is used to start, stop, and preheat
the engine. The ignition switch has 3 positions:
O
FF
, O
N
/P
REHEAT
, and S
TART
. Rotate the key to the
O
N
/P
REHEAT
position until the glow-plug-indicator light
goes out (approximately 7 seconds); then rotate the
key to the S
TART
position to engage the starter motor.
Release the key when the engine starts ( Figure 23 ).
To shut the engine off, rotate the key to the O
FF
position.
Note:
Remove the key from the switch to prevent
accidental starting.
g031597
Figure 23
1. Parking brake 7. Glow-plug-indicator light
2. Cutting-unit-shift lever 8. Hour meter
3. Cutting-unit-drive switch 9. Throttle
4. Alternator light 10. Ignition switch
5. Oil-pressure light 11. Lift-lever lock
6. Temperature light
Throttle
Move the throttle forward to increase the engine
speed and rearward to decrease the engine speed
(
Figure 23 ).
Cutting-Unit-Drive Switch
The cutting-unit-drive switch has 2 positions: E
NGAGE
and D
ISENGAGE
. The rocker switch operates a
solenoid valve on the valve bank to drive the cutting
units (
Figure 23 ).
Hour Meter
The hour meter indicates the total hours of machine
operation. The hour meter starts to function whenever
the key switch is in the O
N
position ( Figure 23 ).
Cutting-Unit-Shift Lever
To lower the cutting units to the ground, move the
cutting-unit-shift lever forward. To raise the cutting
units, pull the shift lever rearward to the R
AISE
position
( Figure 23 ).
Note:
The cutting units do not drop unless the engine
is running.
21