Storage
Storing the Battery
If the machine will be stored more than 30 days, remove
the battery and charge it fully. Store the battery in a cool
atmosphere to avoid quick deterioration of the charge in the
battery. To prevent the battery from freezing, make sure
that it is fully charged. The specific gravity of a fully charged
battery is 1.265–1.299.
Preparation for Seasonal
Storage
Follow these procedures anytime you will be storing the
machine for more than 30 days.
Engine
1.
Drain the engine oil from the oil pan and replace the
drain plug.
2.
Remove and discard the oil filter. Install a new oil filter.
3.
Refill the oil pan with 3.3 L (3.5 US qt) of motor oil.
4.
Start the engine and run it at idle speed for
approximately 2 minutes.
5.
Stop the engine.
6.
For storage over 30 days, prepare the fuel system as
follows:
•
Add a petroleum based stabilizer/conditioner to
fuel in the tank.
Follow the mixing instructions from stabilizer
manufacturer. Do not use an alcohol based
stabilizer (ethanol or methanol).
Note:
A fuel stabilizer/conditioner is most
effective when mixed with fresh gasoline and used
at all times.
•
Run the engine to distribute conditioned fuel
through the fuel system for approximately 5
minutes.
•
Stop the engine, allow it to cool, and drain the fuel
tank.
•
Restart the engine and run it until it stops.
•
Start and run the engine until it will not start again.
•
Dispose of fuel properly. Recycle as per local codes
Important:
Do not store
stabilizer/conditioned gasoline over 90
days
7.
Remove the spark plugs and check their condition;
refer to
Replacing the Spark Plugs (page 37)
.
8.
With the spark plugs removed from the engine, pour 2
tablespoons of engine oil into the spark plug hole.
9.
Use the starter to crank the engine and distribute the
oil inside the cylinder.
10.
Install the spark plugs and tighten to recommended
torque; refer to
Replacing the Spark Plugs (page 37)
.
Note:
Do not install the wires on the spark plugs.
11.
Check anti-freeze protection and add as needed for
expected minimum temperature in your area.
12.
Secure all fuel system fittings.
13.
Thoroughly clean and service the air cleaner assembly.
14.
Seal the air cleaner inlet and the exhaust outlet with
weatherproof tape.
49
Summary of Contents for 30809 Groundsmaster 3500-G
Page 10: ...121 3533 1 Read the Operator s Manual for information on maintenance 10...
Page 50: ...Notes 50...
Page 51: ...Notes 51...
