9
1
2
2
4
3
Figure 2
1.
Tensioning cap
2.
Thrust washers
3.
Spacers
4.
Small (rear) castor
spindle
3. Ensure that all four castor wheels are set at the same
height-of-cut; then roll the cutting unit off of the
wooden pallet.
Installing the Drive Shaft to the
Traction Unit
Slide the smaller yoke end of the drive shaft onto the
traction unit PTO shaft while aligning the mounting holes
(Fig. 3). Secure them with a roll pin. Do not install the front
end of the drive shaft at this time.
1
Figure 3
1.
Drive shaft
Connecting the Right-Hand
Push Arm to the Cutting Unit
The right-hand push arm is spring loaded to about
100 lb. (45 kg). Sudden release of the push arm
could cause injury.
Another person is needed to push the arm down
during this procedure.
Warning
1. Remove the 2 self-tapping screws securing the PTO
shield to the top of the cutting unit gear box mounting
plate and remove the shield (Fig. 4).
1
Figure 4
1.
PTO shield
2. Move the cutting unit into position in front of the
traction unit.
3. Measure the distance from the end of the right-hand
push arm to the center of the ball joint (grease fitting)
(Fig. 5). The distance should be 2-3/4 in. (70 mm). If
the distance is not 2-3/4 in. (70 mm), loosen the jam nut
securing the ball joint to the push arm and rotate the
ball joint in or out until the correct distance is attained
(Fig. 5). Do not tighten the jam nut at this time.
Summary of Contents for 30716
Page 23: ...23 Troubleshooting 85 To 110...
