Toro 30639, Installation Instructions Manual, Page: 4 / 12

3
Installing the Hazard Switch
Parts needed for this procedure:
1 Switch, hazard
2 Cable tie
Procedure
1. Remove the plug from the hole in the top of the
steering tower (
Figure 4 ).
g016658
1
2
3
Figure 4
1. Turn signal switch 3. Plug
2. Hazard switch
2. Install the hazard switch into the hole in the steering
tower (
Figure 4 ).
3. Unplug the wiring harness connector from the turn
signal switch (
Figure 4 ).
4. Plug the wiring harness connector, labeled Turn Signal,
into the turn signal switch and the connector, labeled
Hazard, into the hazard switch.
5. Secure the wiring harness to the existing wiring harness
with the 2 cable ties.
Note:
When routing the wiring, ensure that the
operation of the tilt steering does not damage the
harness or pull on the wires.
4
Installing the Headlights
Parts needed for this procedure:
1 Headlamp bracket, left hand (for model without cab)
1 Headlamp bracket, right hand (for model without cab)
1 Headlamp bracket, right hand (for model with cab)
1 Headlamp bracket, left hand (for model with cab)
1 Headlamp right hand
1 Headlamp left hand
2 Flange head bolt, 1/2 1–1/4 inch
2 Flange nut, 1/2 inch
2 Headlight wiring cover (for model without cab)
8 Plastic plug
6 Cable ties
For Traction Units Not Equipped With
a Cab
1. Unplug the wiring harness connector from each
existing headlight.
2. Remove the fasteners securing each head light bracket
to the operator's platform. Retain the mounting
fasteners (
Figure 5 ).
Figure 5
1. Head light bracket
3. Using the fasteners previously removed, mount the
R.H and L.H headlight brackets to the existing holes
in the front of the operator's platform. Position the
brackets as shown in
Figure 6 and Figure 7 . Torque to
95 to 115 ft-lbs (129 to 156 N-m).
4