Toro 30433, Operator'S Manual

Page: 13 / 64

Step
2
Installing the Handle
Assembly
Parts needed for this step:
1 Handle assembly
2 Flanged bolt (3/8 x 1 inch)
2 Flanged bolt (3/8 x 1-1/4 inches)
4
Flange nut (3/8 inch)
Procedure
1. Align handle with upper mounting holes in
rear frame (Figure 5).
2. Secure the handle at each upper mounting hole
with a flange bolt (3/8 x 1-1/4 inches) and
flange nut (3/8 inch) (Figure 5).
3. Select the low position for the lower mounting
hole (Figure 5).
4. Secure the handle at each lower mounting hole
with a flange bolt (3/8 x 1 inch) and flange nut
(3/8 inch) (Figure 5).
Note:
The handle position can be adjusted to
match the operator’s height preference.
Figure 5
1. Upper handle 6. Lower mounting holes
2. Rear frame 7. Low position
3. Flange nut, 3/8 inch 8. High position
4. Flange bolt, 3/8 x 1 inch 9. Flange bolt, 3/8 x 1–1/4
inch
5. Upper mounting hole
Note:
Install the handle assembly before the
fuel tank.
Step
3
Installing the Fuel Tank
Parts needed for this step:
1 Fuel tank with studs installed
2 Bolt (5/16 x 7/8 inch)
2 Lock nut (5/16 inch)
4 Washer (5/16 inch)
1 Hose clamp
2 Lock washer (5/16 inch)
2 Spring
Procedure
1. Align fuel tank with the top of the rear frame
(Figure 8).
2. Push the fuel line through the grommet and
hole in the hydraulic oil filter bracket (Figure 6).
13