Toro 30318, Operator'S Manual

Page: 12 / 56

Step
1
Removing the Shipping
Bracket and Shipping
Washers
No Parts Required
Procedure
1. Remove the center gage wheel nut, 2 large
washers, angle bracket and 1 small washer
(Figure 3). Discard the 2 large washers and the
angle bracket.
Figure 3
1. Center Gage Wheels and
Spacer
4. Angle bracket-discard
2. Nut 5. Small washer
3. Large washer-discard
2. Install the center gage wheels with the
previously removed bolt, spacer, small washer,
and nut (Figure 4).
Figure 4
1. Center Gage Wheels and
Spacer
4. Washer
2. Nut 5. Spacer
3. Bolt
Step
2
Installing the Handle
Assembly
Parts needed for this step:
1 Handle assembly
4 Flanged bolt, (3/8 x 1 inch)
4 Flange nut, (3/8 inch)
Procedure
1. Align handle with upper mounting holes in
rear frame (Figure 5).
2. Secure the handle at each upper mounting hole
with a flange bolt (3/8 x 1 inch) and flange nut
(Figure 5).
3. Select the low position for the lower mounting
hole (Figure 5).
4. Secure the handle at each lower mounting hole
with a flange bolt (3/8 x 1 inch) and flange nut
(Figure 5).
Note:
The handle position can be adjusted to
match the operator’s height preference.
12