Form No. 3377-954 Rev B
Backhoe Drive Release Kit
RT600 Traction Unit with Backhoe
Model No. 25433
Model No. 25433E
Installation Instructions
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Qty.
Use
Valve assembly
1
Hydraulic fitting (90 degree)
2
Elbow fitting (90 degree)
1
Valve bracket
1
Flange-head bolt (1/4 x 1-3/4 inches)
2
Flange nut (1/4 inch)
2
Flange-head bolt (M8 x 1-1/4 inch)
2
Orifice (0.080 inch)
1
Install the valve assembly.
Elbow fitting (45 degree)
2
Hydraulic hose
2
Cable tie
5
Installing the hydraulic hoses.
Valve switch
1
Switch mounting bracket
1
Bolt (1/4 x 1/2 inch)
2
Bolt (5/16 x 1 inch)
2
Washer
2
Nut (5/16 inch)
2
10 Amp fuse
1
Cable ties
5
Install the valve switch.
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals
known to the State of California to cause cancer,
birth defects, or reproductive harm.
Installing the Valve Assembly
WARNING
If the engine has been running, the hydraulic fluid
and components may be hot and could burn you.
Allow the machine to cool before performing this
procedure.
1.
Park the machine on a firm, level surface.
2.
Lower all attachments to the ground.
3.
Turn off the engine, remove the key, and allow the
machine to cool completely.
4.
Remove the left-side, engine cover; refer to the
RT600
Traction Unit Operator’s Manual
for instructions.
5.
Loosen the 4 bolts securing the access panel in front of
the traction unit seat, and remove the panel (Figure 1).
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3377-954* B
Summary of Contents for 25433
Page 8: ......
