Toro 22805, Operator'S Manual

Page: 8 / 16

Removing an Auger
1. Raise the loader arms so the auger comes out of the
hole.
Note:
If you have a 24-inch extension installed
between the drive head and the auger, it may be
necessary to raise the auger as high as possible and
then move the traction unit backward to pull the auger
the rest of the way out of the hole.
2. Set the auger down in its storage location.
3. While lowering the arms, drive slowly backwards until
the auger is horizontal.
4. Stop the engine.
5. Remove the bolt and nut securing the drive head to the
auger or extension.
6. Start the engine and back the traction unit away from
the auger.
7. If you used an extension, remove the bolt and nut
securing it and pull it off the auger.
8