Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
Handle
1
Bolt (5/16 x 1-1/4 inches)
2
Washer
4
Thin nylon insert locknut (5/16 inch)
2
Bolt (5/16 x 1-1/2 inches)
2
Carriage bolt
1
Locknut (5/16 inch)
2
Bag support rod
1
Bag aligning plate
1
Cap locknut
3
1
Cable tie
3
Install the handle.
2
No parts required
–
Install the starter rope.
3
Discharge tunnel plug
1
Install the discharge tunnel plug.
4
No parts required
–
Fill the crankcase with oil.
Note:
Determine the left and right sides of the machine
from the normal operating position.
1
Installing the Handle
Parts needed for this procedure:
1
Handle
2
Bolt (5/16 x 1-1/4 inches)
4
Washer
2
Thin nylon insert locknut (5/16 inch)
2
Bolt (5/16 x 1-1/2 inches)
1
Carriage bolt
2
Locknut (5/16 inch)
1
Bag support rod
1
Bag aligning plate
3
Cap locknut
3
Cable tie
Procedure
1. Mount the handle to the outside of the mower
housing (using the bottom hole) with two bolts
7
