![Toro 22176 Operator'S Manual Download Page 8](http://html1.mh-extra.com/html/toro/22176/22176_operators-manual_1133039008.webp)
Note:
You can adjust the handle height
for comfortable operation. Stand behind the
handle to determine the height. To adjust the
handle height, position the cap screws and the
locknuts that secure the handle latches to the
handle into the other mounting holes in the
latches.
3. Slide the bag support rod through the second
from the top mounting holes in the handle and
secure each end with a cap locknut (Figure 3).
4. Use a cable tie to secure the control cables to
the left handle below the bag support rod.
Step
2
Installing the Starter Rope
No Parts Required
Procedure
Pull the starter rope through the rope guide on the
handle (Figure 4).
Figure 4
1. Starter rope
2. Rope guide
Note:
To make the rope easier to install, squeeze
the control bar on the handle.
Step
3
Installing the Fuel Tank and
the Fuel Line
Parts needed for this step:
2
Self-tapping screw
1
Fuel tank
Procedure
1. Start the 2 self-tapping screws into the bottom
of the fuel tank and then remove the screws
(Figure 5).
Figure 5
1. Tank base
4. Fuel tank
2. Fuel tank bracket
5. Self-tapping screw (2)
3. Plastic clips
2. Hook the plastic clips on the front of the fuel
tank onto the fuel tank bracket (Figure 5).
3. Secure the fuel tank to the tank base with
the 2 self-tapping screws (Figure 5).
Do not
overtighten the screws.
4. Remove the red cap from the end of the fuel
line and from the end of the elbow fitting on
the fuel tank (Figure 6).
8