Toro 138-2995, Installation Instructions Manual, Page: 3 / 8

4
Routing and Connecting
the Power Harness
Parts needed for this procedure:
1 Power harness
6 Cable tie
Routing the Ring Terminals
to the Battery and Electrical
Compartment
Important:
Route the power harness away from
exhaust components and moving parts.
1. Route the 2 ring terminals of the power harness
under the area where the battery compartment
is located (
Figure 4 or Figure 5 ).
g252785
Figure 4
Machines without a Cab
1. Power harness 2. Ring terminals
g252784
Figure 5
Machines with a Cab
1. Power harness 2. Ring terminals
2. Route the ring terminal of the power harness
labeled B+ through the opening at the back,
outboard corner battery compartment (
Figure 6 ).
g252791
Figure 6
1. Power harness 3. Ring terminal (B+)
2. Fuse (10 A) and fuse
holder 4. Ring terminal—power
harness (
GROUND BLOCK
)
3. Route the ring terminal of the power harness
labeled
GROUND BLOCK
under the battery
compartment and through the opening near
the forward inboard corner of the electrical
compartment (
Figure 6 ).
Assembling the Ring Terminals
to the Battery Cable and Ground
Block
1. Remove the battery-clamp nut from the battery
clamp bolt of the positive battery cable (
Figure
14 ).
3