Toro 138-2995, Installation Instructions Manual, Page: 1 / 8

Form No. 3423-121 Rev A
Power Harness Kit
Groundsmaster ® 4500-D, 4700-D or Reelmaster ® 7000-D Traction
Unit
Model No. 138-2995
Installation Instructions
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
1
No parts required
–
Prepare the machine.
2
No parts required
–
Disconnect the battery.
3
No parts required
–
Open the hood.
Power harness 1
4
Cable tie 6
Route the power harness.
5
No parts required
–
Connect the battery.
6
No parts required
–
Close the battery compartment door
and the hood.
1
Preparing the Machine
No Parts Required
Procedure
CAUTION
If you leave the key in the ignition switch,
someone could accidently start the engine
and seriously injure you or bystanders.
Remove the key from the ignition switch
before you do any maintenance.
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Lower the cutting units.
4. Shut off the engine and remove the key.
2
Disconnecting the Battery
No Parts Required
Accessing the Battery
Release the latch and open the door to the battery
compartment (
Figure 1 ).
© 2018—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420 Register at www.Toro.com. Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3423-121* A