Toro 136-1664, Installation Instructions Manual

Page: 8 / 12

Installing a Front-Weight
Kit
For Machines with 2 or More
Accessory-Mount Kits
If 2 or more accessory-mount kits (i.e., bucket kit or
universal mount kit) are added to any of the 4 locations
shown in
Figure 11 , add a front-weight kit. Contact
your Authorized Service Dealer for the front-weight kit.
g037417
Figure 11
1. Add a front-weight kit when 2 or more accessory-mount kits
are installed at these positions.
Operation
Mounting Attachments
Use only Toro-approved attachments and accessories.
The maximum capacity is 11.3 kg (25 lb).
Use the top bracket and hinge bracket for mounting
attachments or accessories; secure them using the
holes in the mounting brackets.
Secure the hinge bracket when not in use; refer to
Securing the Hinge Bracket (page 9) .
Mounting a Bucket
Note:
If desired, you can remove the hinge bracket
and mount the bucket using the welded support
bracket.
1. Loosen the knob and raise the top bracket.
Tighten the knob to hold it in place (
Figure 12 ).
2. If you removed the hinge bracket, place the
bottom lip of the bucket over the bottom ledge of
the welded support bracket (
Figure 12 ).
3. Loosen the knob and lower the top bracket as far
as possible over the rim of the bucket. Tighten
the knob (
Figure 12 ).
g037421
Figure 12
1. Knob 3. Bottom ledge of the
support bracket
2. Top bracket over the rim of
the bucket
8