Toro 110-2026, Installation Instructions

Page: 1 / 2

Form No. 3354-114 Rev A
36in Bagger Enhancement Kit
For Turbo Force® Cutting Unit for Mid-Size Mowers
Model No. 110–2026
Installation Instructions
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step Description Qty. Use
1
No parts required
–
Prepare the mower deck for
installation.
Rubber bafe 1
Metal bafe stiffener 1
Carriage bolt (5/16 x 1 inch) 5
2
Locknut (5/16 inch) 5
Install the bafes.
Step
1
Preparing the Mower Deck
No Parts Required
Procedure
1. Position the mower on a flat surface.
2. Disengage the PTO, move the motion control
levers to the neutral locked position and set
the parking brake.
3. Stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
4. Lift the front of the machine and support the
machine using jack stands.
5. Thoroughly clean the mower deck. All debris
must be removed to ensure the baffle will fit
properly against the mower deck.
6. Repair all bent and damaged areas of the
mower deck and replace any missing parts.
Mechanical or hydraulic jacks may fail to
support the machine and cause a serious
injury.
• Use jack stands when supporting the
machine.
• Do not use hydraulic jacks.
Step
2
Installing the Bafes
Parts needed for this step:
1 Rubber bafe
1 Metal bafe stiffener
5 Carriage bolt (5/16 x 1 inch)
5 Locknut (5/16 inch)
Procedure
Note:
Install bolts as shown in Figure 1.
1. Install rubber baffle and the baffle stiffener
with 5 bolts (5/16 x 1 inch) and 5 locknuts
(5/16 inch) (Figure 1).
2. Rotate the cutting blades and make sure they
do not hit the baffles.
© 2005—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com. Original Instructions (EN)
Printed in the USA.
All Rights Reserved