Calibrating the Throttle
Actuator
Service Interval:
Every 500 hours—Calibrate the
throttle actuator.
1.
Park the machine on a level surface.
2.
Shift the transmission lever to the P (P
ARK
)
position.
3.
With the engine running and your foot off the
brake pedal, press and hold the display button
for 10 seconds (
The km/h or mph on the display will start blinking.
g367226
Figure 91
1.
Display button
4.
While pressing and holding the display button,
turn the key switch from the R
UN
position to the
S
TART
position, then simultaneously let go of
both.
The throttle actuator angle will start to increase
(1 degree every 2 seconds). When the
calibration process is complete, a new offset is
created, and the angle on the display shows
zero again.
The calibration process takes approximately 30
to 60 seconds to complete.
Note:
Do not touch anything during the
calibration process, as this will cancel the
process, requiring you to restart the procedure.
Note:
During calibration, the engine speed
(rpm) should remain constant. Only at the end of
the calibration process you may hear the engine
speed slightly increase. If the engine speed
increases continuously, there may be an issue,
and the engine speed is not communicating with
the TEC controller.
82
Summary of Contents for 08102
