Toro 08102, Operator'S Manual

Page: 64 / 104

Using the Cruise Control
In order to use cruise control, your seat belt must be
fastened, and you need to be driving at the following
ground speed based on your selected gear:
•
H (High Forward) gear— 6 km/h (4 mph) or
greater
•
L (Low Forward) gear— 3 km/h (2 mph) or greater
1. Move the cruise control switch to the O
N
position
( Figure 71 ).
2. When you reach the desired drive speed, press
the cruise control switch up to engage/set the
cruise control (
Figure 71 ).
To increase the cruise control speed, press the
switch up until you reach the desired speed
(
Figure 71 ).
Note:
Press the button 1 time to increase the
ground speed by an increment of 1 km/h (1
mph).
To disengage cruise control, press the switch to
the down, O
FF
position ( Figure 71 ).
Note:
When you press the brake pedal, the
cruise control disengages.
g391453
Figure 71
1. Set cruise control/increase
cruise speed 3. O
FF
positon
2. O
N
position
Adjusting the Ground
Speed Governor
1. Press and hold the button ( Figure 72 ) for at least
10 seconds.
The set speed will blink.
2. Press the button 1 time to increase the ground
speed by an increment of 1 km/h (1 mph).
Note:
The maximum ground speed that you can
increase to is 40 km/h (25 mph); the minimum
is 8 km/h (5 mph).
g367226
Figure 72
1. Button
Stopping the Machine
To stop the machine, remove your foot from the
accelerator pedal, then press the brake pedal.
Shutting Off the Engine
1. Stop the machine.
2. Shift the transmission lever to the P (P
ARK
)
position.
3. Rotate the key switch to the O
FF
position and
remove the key.
64