Adjusting the Front Ride
Height
Owner-provided tools: spring-adjuster wrench,
Toro Part 139-4678
; refer to your authorized Toro
distributor.
Important:
Make height adjustments only if there
is uneven tire wear or if you are adding additional
weight to the front of the machine (e.g., adding
a BOSS plow).
1.
If you are adding weight to the front of the
machine, adjust the ride height.
Check the tire pressure to ensure that the front
tires are inflated properly; refer to
Tire Pressure (page 58)
.
The ground clearance should be 23 cm (9
inches) for standard wheels and tires or 25 cm
(10 inches) for the larger accessory wheels and
tires.
2.
If the ground clearance is not correct, use the
spring-adjuster wrench to rotate the collar on the
shock absorber to align the wheel (
).
Note:
If the collar is difficult to rotate, raise the
front of the machine;
Raising the Machine (page
.
g364721
Figure 103
1.
Shock-absorber spring
3.
Spring length
2.
Collar
90
Summary of Contents for 08102
