Adjusting the Parking Brake
Check the parking brake adjustment every 200
hours.
1. Pry the rubber cover off of the parking brake.
2. Loosen the set screw securing the knob to the
parking brake lever (Figure 47).
Figure 47
1. Parking brake lever
3. Set screw
2. Knob
3. Rotate the knob until a force of 30-35 lb
(133-156 N) is required to actuate the lever.
4. Tighten the set screw and install the rubber
cover.
Cleaning
Washing the Vehicle
The vehicle should be washed as needed. Use
water alone or with a mild detergent. A rag may
be used, however the hood will loose some of its
luster.
Important:
Do not use high pressure water
when washing the vehicle. It may damage the
electrical system, loosen important decals, or
wash away necessary grease at friction points.
Avoid excessive use of water, especially near
the control panel, motor, and batteries.
38
Summary of Contents for 07287TC
Page 42: ...Schematics Electrical Schematic Rev A 42...
Page 43: ......
