Note:
This procedure is only necessary for batteries in
Model No. 07266TC and 07273TC.
If the battery is not filled with electrolyte or activated, it
must be removed from the vehicle, filled with electrolyte,
and charged. Bulk electrolyte with 1.260 specific gravity
must be purchased from a local battery supply outlet.
1. Locate the battery on the right side of the machine,
behind the passenger seat. Remove the battery cover.
2. Remove the battery hold-down and lift the battery
out of the battery base.
DANGER
Battery electrolyte contains sulfuric acid which
is a deadly poison and causes severe burns.
•
Do not drink electrolyte or allow it to contact
your skin, eyes or clothing. Wear safety
glasses to shield your eyes and rubber gloves
to protect your hands.
•
Fill the battery where clean water is always
available for flushing the skin.
3. Remove the filler caps from the battery and slowly
fill each cell until electrolyte is just above the plates.
4. Replace the filler caps and connect a 3 to 4 amp
battery charger to the battery posts. Charge the
battery at a rate of 3 to 4 amp for 4 to 8 hours
(12 volts). Do not overcharge the battery.
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks
and flames away from battery.
5. When the battery is charged, disconnect the charger
from the electrical outlet and battery posts.
6. Remove the filler caps. Slowly add electrolyte to
each cell until electrolyte is up to the fill line. Install
the filler caps.
Important:
Do not overfill the battery.
Electrolyte will overflow onto other parts of the
vehicle and severe corrosion and deterioration
will result.
7. Install the battery; refer to Installing the Battery
in the Electrical System Maintenance section in
Maintenance.
3
Reading the Manual and
Viewing the Safety Training
Material
Parts needed for this procedure:
1
Operator’s Manual
1
Engine Operator’s Manual
1
Parts Catalog
1
Safety Training material
1
Registration Card
1
Predelivery Inspection Form
1
Certificate of Quality
2
Key
Procedure
•
Read the
Operator’s Manual
and
Engine Operator’s
Manual
.
•
View the safety training material.
•
Fill out the registration card.
•
Complete the
Predelivery Inspection Form
.
•
Review the
Certificate of Quality
.
12
Summary of Contents for 07266TC
Page 10: ...99 7350 1 Maximum tongue weight is 50 lb 23 kg maximum trailer weight is 400 lb 181 kg 10...
Page 41: ...Notes 41...
Page 42: ...Notes 42...
Page 43: ...Notes 43...
