Troubleshooting
Condition
Possible Causes
Corrective Action
The sweeper is not
picking up debris.
The brush is damaged.
The brush height is too high.
The Front flap height is too low or too high.
Replace brush.
Adjust brush height. See Brush Height Adjustment.
Adjust front flap height. See Front Flap Adjustment
The sweeper has
excessive vibration.
Check the bearings on the brush shaft. If they are
excessively hot, check the bearings for damage.
Foreign materials are wrapped around brush.
Replace any damaged bearings.
Clean off any foreign objects.
The diagnostic light on
the sweeper does not
illuminate when pressing
a remote button.
There is frequency interference.
Associate the remote control to the base unit. Refer
to
Associate the Remote Control and the Base Unit
(page 29)
.
Checking Fault Codes
If the diagnostic light indicates that there is a system fault (refer to
(page )
), check the fault codes to determine
what is wrong with the machine.
31
Summary of Contents for 07068
Page 34: ...Notes 34...
