Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first 5 hours
• Change the engine oil.
After the first 8 hours
• Check the condition of the drive belt.
• Check the tension of the starter-generator belt.
After the first 50 hours
• Check the air filter for the carbon canister.
After the first 100 hours
• Perform the guidelines for breaking in a new machine.
Before each use or daily
• Inspect the seat belt(s) for wear, cuts, and other damage. Replace the seat belt(s) if
any component does not operate properly.
• Check the tire pressure.
• Check the engine-oil level.
• Check gear-shift operation.
• Check the brake-fluid level.
• Wash the machine.
Every 50 hours
• Remove the air-cleaner cover and clean out the debris. Do not remove the
air-cleaner element.
• Clean out the debris in the dust cap.
• Under special operating conditions (refer to Maintaining the Machine under Special
Operating Conditions)—replace the air-cleaner element. Replace the air-cleaner
element sooner if dirty or damaged.
• Under special operating conditions (refer to Maintaining the Machine under Special
Operating Conditions)—change the engine oil.
Every 100 hours
• Under normal operating conditions—replace the air-cleaner element. Replace the
air-cleaner element sooner if dirty or damaged.
• Under normal operating conditions—change the engine oil.
• Check the spark plug.
• Check the condition of the tires and rims.
• Torque the wheel-lug nuts.
• Inspect the steering and suspension for loose or damaged components.
• Check the front wheel camber and toe-in.
• Check the transaxle-fluid level.
• Check the operation of the neutral gear-shift position.
• Clean the engine-cooling areas.
• Inspect the brakes.
Every 200 hours
• Check the air filter for the carbon canister.
• Check the condition and tension of the drive belt.
• Check the tension of the starter-generator belt.
Every 300 hours
• Grease the front wheel bearings.
Every 400 hours
• Inspect the fuel lines and connections.
• Replace the fuel filter.
• Clean the primary drive clutch.
• Replace the service and parking-brake pads.
Every 800 hours
• Change the transaxle fluid.
Every 1,000 hours
• Change the brake fluid.
Yearly
• Complete all of the yearly maintenance procedures that are specified in the engine
owner's manual.
Note:
Download a free copy of the electrical schematic by visiting
www.Toro.com
and searching for your
machine from the Manuals link on the home page.
Important:
Refer to your engine owner’s manual for additional maintenance procedures.
27
Summary of Contents for 07059LT
Page 56: ...Notes...
Page 60: ......
