Toro 03673, Operator'S Manual

Page: 10 / 48

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
1
No parts required
–
Adjust the tire pressure.
2
No parts required
–
Adjust the step height.
3
No parts required
–
Adjust the control arm position.
Front hose guide-R.H. 1
4
Front hose guide-L.H. 1
Install the cutting units
5
No parts required
–
Adjust the turf compensation spring.
6
Cutting unit kickstand 1 Install the Cutting Unit Kickstand.
Media and Additional Parts
Description Qty. Use
Operator's Manual 1 Read the Operator's Manual before operating the machine.
Engine Operator's Manual 1 Use to reference engine information
Parts Catalog 1 Use to reference part numbers
Operator Training Material 1 Review before operating the machine
Cutting Performance Paper 1 Used for adjusting the cutting unit bedknife to reel
Shim 1 Used for adjusting the cutting unit bedknife to reel
Note:
Determine the left and right sides of the machine
from the normal operating position.
1
Adjusting the Tire Pressure
No Parts Required
Procedure
The tires are over-inflated for shipping. Therefore, release
some of the air to reduce the pressure. Correct air pressure in
the front and rear tires is 83 to 103 kPa (12 to 15 psi).
Important:
Maintain even pressure in all tires to ensure
uniform contact with the turf.
2
Adjusting the Step Height
No Parts Required
Procedure
The height of the steps can be adjusted for the operators
comfort.
1. Remove the 2 bolts and nuts securing the step brackets
to the traction unit frame (Figure 2)
10