5. Connect the coolant tube to the port below the
machine's base, and then put it on top of the tray on the
coolant tank, as shown in the following image.
Figure 4-5: Coolant tube connected to the machine's
base and the coolant tank.
4.4.3 Install the Blade Tensioner Handles
Install and hand-tighten the three blade tensioner
handles.
Figure 4-6: Installing the blade tensioner handles.
4.4.4 Remove the Shipping Bolts on the Rear Cage
The rear cage is secured to the frame for shipment.
Remove the two bolts.
Figure 4-7: Removing the shipping bolts from the rear
cage and the frame.
4.4.5 Install the Rear Roller
1. Install the two spacers on either end of the roller posts.
Figure 4-8: Installing the spacer on one end of the
roller's post.
2. Put one roller post into the frame, and then squeeze in
the spring-loaded post and slide it into the opposite end
of the frame.
Figure 4-9: Squeezing the spring-loaded post.
4.4.6 Make Air Connections
Connect the air line from your site to the input port on
the FRL Filter-Regulator-Lubricator (on the back of the
machine).
©Tormach® 2020
Specifications subject to change without notice.
Page 22
UM10538: Tormach AF50 Autofeed Bandsaw (Version 0320A)
For the most recent version, see tormach.com/support
4: INSTALLATION
