TECHNICAL DOCUMENT
Make Electrical Connections
1. Route the ATC power cable and the USB cable toward the rear of the machine and out of one of the
enclosure knockouts.
2. Put the USB cable in the access hole in the rear of the stand toward the controller.
3. Put the USB cable into any open USB port on the PathPilot controller.
4. Connect the ATC power cable to the ATC Power connector on the side of the electrical cabinet (below the
Enclosure Lights Power connectors).
Verify the Installation
1. Power on the machine and the PathPilot controller.
a. Turn the Main Disconnect switch to
ON
on the side of the electrical cabinet.
b. Twist out the Emergency Stop button on the operator box, which enables movement to the machine axes
and the spindle.
c. Press the Reset button on the operator box.
d. Bring the machine out of reset and reference it.
IMPORTANT!
You must update your controller to the latest version of PathPilot before operating the
Automatic Tool Changer. If you don't, there's a risk that the ATC could become inoperable.
2. If you have not yet done so, you must make sure that the PathPilot controller is updated to the latest version
of PathPilot: From the
Status
tab, select
Update
. Then, follow the on-screen instructions.
3. From the PathPilot interface, on the
Settings
tab, select the
ATC
radio button.
Figure 14: ATC radio button on the Settings tab.
The
ATC
tab appears in the PathPilot interface.
Note:
If prompted, you may need to update the firmware for the ATC. Follow the on-screen
instructions.
Page 16
©Tormach® 2020
Specifications subject to change without notice.
tormach.com
TD10627: Owner's Guide: 770MX Automatic Tool Changer (ATC) (1220A)
