INSTALLATION
5. Attach one dark gray, horizontal window retainer to the top and bottom of the front door's window opening
with two sets of two M5 × 0.8 - 10 screws.
NOTICE!
To prevent window damage from over-tightening, use your fingers to tighten the screws.
Figure 24: Window retainers attached to the front door.
6. Repeat Steps 1 through 5 to assemble the remaining front door.
Install the Front Door Assemblies
Each front door is attached to the enclosure by securing it to the linear bearings: the wider door is mounted on the
left side of the enclosure, and the narrower door is mounted on the right side of the enclosure.
To install the front doors:
1. Starting with the top linear assembly, attach the narrow door to the two upper linear bearings with two sets
of four M5 × 0.8 - 10 screws.
Page 19
©Tormach® 2022
Specifications subject to change without notice.
tormach.com
TD10712: Installation Guide: 770MX Enclosure Kit (0522A)
