Quick Start on SkyEasy Smart FPV Glider
Gyro Mode Selection
Self-leveling:
Put the left switch to the middle
position.
Stabilizing:
Put the left switch to the upper position.
Normal:
Put the left switch to the lower position.
How to Use the Special Features
In order to use auto pilot features, you need to
switch the transmitter to self-leveling mode firstly.
That means putting the left switch to the middle
position.
Auto Take-off:
Toss the plane out into air, the motor
will be activated automatically and the plane will fly by itself.
Auto Pilot:
While in the air, the plane will fly at the pre-set height in the direction that tossed out. The plane will return home
when reached the pre-set distance. And then fly around the launch point with the pre-set max radius and minimum altitude.
One-Key Return Home:
Press the “H” key on Tx, the plane will return to the point where it is launched and circle around the
launch point.
Notice: flight parameters, such as distance, circling diameter and height, can be pre-set in your transmitter.
How to setup the flight parameters: press “ESC” to enter menu, and select “6. GPS Setup”. Min alt: minimum altitude; Far dst:
maximum distance; Max rad: maximum radius; Min spd: minimum stall speed.
Warning: it is highly recommended that the pilot doesn’t wear the FPV goggle when precise operations are required, such as
landing and take-off. Otherwise, there will be a danger of crash.
How to Bind Tx with Rx
The Tx and Rx are pre-binded in factory. So no binding required. If there is a situation when binding is required, please follow
the instructions as below:
Get to Start
(1)
install the vertical wing with glue (2) install the main wing (3) install the propeller
(1) Install the flight battery, and keep the plane still on the ground.
(2) Press the button on receiver, and then put the transmitter close to plane
and keep pressing button “A” for 5 seconds while power on the transmitter.
Notice:
(1) Please keep the plane still while binding, to avoid any interference.
(2) Please avoid binding when other similar binding is going on.
