1
Pack
NO.: 84470
1:12
SCALE
FULL
FUNCTION
6
ages
RACING BIKE
PRO . S Y S TE M
ADAPTOR
3.7V
Rechargeable
Battery
Rechargeable Battery Must Be
Recycled Or Disposed Of Properly.
Contents
5
RC Transmitter x 1
-RC Vehicle (Vehicle) x 1
-RC Transmitter (Transmitter) x 1
3.7V Lithium
-USB Cable Adaptor x1
3.7V
150mAh
For Vehicle
-Instruction Manual x 1
RC Vehicle x 1
USB Cable Adaptor
(Included)
1.
The 3.7V rechargeable battery pack must be charged before use by utilizing the USB
Cable Adaptor which included.
2.
Do not overcharge the battery pack. Do not charge for more than 4 hours.
3.
Do not charge the battery pack if it shows leakage, corrosion, or has loose or exposed
wires or other damage.
4.
Do not cover the battery pack with any sort of materials while charging.
5.
Do not touch the battery pack when it is hot. Wait until the battery pack cools before
installing it in the Vehicle and before recharging.
6.
Do not dispose of the battery in fire.
7.
Do not dismantle the battery or charger, and do not cut the battery or charger cables.
8.
The battery pack will be warm after charging, and hot after use in a vehicle.
9.
The supply terminals are not to be short-circuited.
10.
Rechargeable batteries are only to be charged by adults.
11.
Battery replacement must be only made by adults.
12.
The USB Cable Adaptor is not a toy.
13.
Charge only type (150mAh Max.) rechargeable battery packs. Other types of
batteries may burst causing injury to persons and damage. This power unit is
intended to be correctly orientated in a vertical or floor mount position. This
USB Cable Adaptor is intended to be used for charging 3.7V rechargeable
battery pack with capacity 150mAh Max. It cannot be used for charging
non-rechargeable batteries. Regular examination of USB Cable Adaptor for
any damage to their cord, plug, enclosure and other parts, and that, in the
event of such damage, it must not be used with the charger or battery pack
charge until such damage has been repaired. Note that the AAA battery is
non-rechargeable and is not to be recharged. Only batteries of the same or
equivalent type as recommended are to be used. It will need replacement
when transmission is poor.
14.
Exhausted batteries are to be removed from the product.
15.
Non-rechargeable batteries are not to be recharged.
16.
Diuerent types of batteries or new and used batteries are not to be mixed.
17.
Rechargeable batteries are to be removed from the toy before being charged.
18.
Batteries are to be inserted with the correct polarity.
19.
The packaging has to be kept since it contains important information.
Battery Installation
For Transmitter (Fig. 1 and Fig. 2)
1. Unscrew the screw on the battery cover
2. Open the battery cover
3. Install 2 new 1.5V “AAA” batteries with correct polarities (+/-)
as shown inside the battery compartment
4. Close the battery cover
5. Tighten the screw on the battery cover
Connect the 3.7V rechargeable battery pack to the USB Cable Adaptor.
The charging time for a full charge is about 1 hour. Full charge battery usage Max. 30 mins.
Disconnect the rechargeable battery pack from the USB Cable Adapter.
Transmitter
Vehicle
2.4 GHz
Signal Match
Button
Steering
Accelerator Wheel
Trigger
Charging plug
