9
desired open position when the open limit switch approaches it.
The higher magnet bracket must be installed at left side and lower magnet bracket must be installed
at right side from the view inside of property.
Finally adjust the magnet to the proper position by moving
the gate with the motor.
The magnet should be 20-30mm away from the magnetic limit switch.
If it is too
far away, the switch will fail to work. The distance between the magnet and the opener should be 10-15mm
with the opener cover on. Adjust the position of the magnet until the positions of the opening and closing
meet the requirement.
Important Note:
Please note the two magnet brackets (fixed plate) are different: one is higher and the other
is lower.
Connecting of Power Supply
WARNING: NEVER connect the gate opener to the power outlet before all
the installations have been done.
The power supply cord should be at least 3×2mm2 (3C×14AWG). Connect the live
wire and neutral wire to the “L” (1#) and “N” (3#) terminal of the control board
respectively; and connect the earth wire to “
” (2#) terminal of the control board.
NOTE: The power supply cord is not included in the package.
Connecting of the Control Board
Warning
：
Before making any electrical wire connection or/and setting the control board, make
sure that the power switch is OFF.
Warning: A photocell is included in the package. The photocell must be installed with the gate
opener for safety protection or the gate opener could not close properly.
1. Contactors
The
A1
terminal of both contactors should be wired to the
“6” terminal of the control board.
The
A2
terminal of contactor1 should be connected into the “8” terminal the control board.
The
A2
terminal of contactor2 should be connected into the “7” terminal the control board.
2. Limit Switches
The
RED
wire of the limit switches should be connected into the “9” terminal.
The
BLACK
wire of the limit switches should be connected into the “10” terminal.
The
YELLOW
wire of the limit switches should be connected into the “11” terminal.
3. Warning Light (Included in some models, refers to the actual package)
One wire of the warning light should be connected into the “4” terminal, another should be connected into
the “5” terminal.
4. Photocell Beam System (PBS) (Normally Closed)
Use a 2-core cable to connect the
“+ ~”
terminal of the photocell’s emitter to the “12” terminal, the
“- ~”
terminal to the “13” terminal. Also the
“+ ~”
and
“- ~”
terminals of the photocell’s receiver should be
connected to the “12” and “13” terminals in parallel.
Use another 2-core cable to connect the
“NC”
terminal of the receiver to the “14” terminal, the
“COM”
terminal to the “15” terminal.
5. Push Button (Optional)
The push button should be wired to the “15” and “16” terminals. The gate opener works alternately by
Warning: Improper magnets installation may cause the gate crash into end
barrier, which is very dangerous !
