Topens MultiRuta CASAR 800, User Manual

Page: 13 / 33

10
3. INSTALLATION SECTION

Wear protective goggles when working overhead to protect your eyes from injury.

Disengage all existing garage door locks to avoid damage to garage door. To avoid serious
personal injury from entanglement, remove all ropes connected to garage door before installing
opener.

Installation of this product shall comply with ZH1/494, VDE 0700 Part 238, and VDE 0700 Part 1. It
is recommended that the opener be installed 2.1m (7 feet) or more above the floor where space
permits.
3.1 Position the Header Bracket
The header bracket must be rigidly fastened to a structural support of the garage. Reinforce the wall or
ceiling with a 40 mm (1-1/2") board if necessary. Failure to comply may result in improper operation of
safety reverse system.
You can attach the header bracket either to the header wall (1) or to the ceiling (3). Follow the instructions
which will work best for your particular requirements.
With the door closed, mark the vertical centerline (2) of the garage door. Extend line onto header wall above
the door.
Open door to highest point of travel. Draw an intersecting horizontal line (4) on header wall 5 cm (2") above
high point to provide travel clearance for top edge of door.