Topcon UA-10 Series, Instruction Manual

Page: 153 / 534

151
3.13.2 Create new Correction factor file
Creates new Area correction file.
To create a new file, go through the following steps.
1
Select the [Setting]-[Area correction] to open the [Area correction] dialogue.
2
Select the [Create].
3
Displayed Area correction file are enabled. Edit the [File name] and [Comment] directly.
Set [Tristimulus values], [Horizontal split count], and [Vertical split count] and then, edit
each correction factor in grid.
4
Press [Save] button to save the Area correction file.
・
An Area correction file is saved as CSV format. An Area correction file can be
edited directly.
・
When you apply an area correction factor to measured image, set them in [Recipe
setting]-[Area correction].
☞
“
3.10.4 Set Area Correction
”
Note
When you edit values other than correction factor in an Area correction
file, file data may not read correctly
When you edit a file, edit only correction factor data.
Memo